background image

Battery 

Installation

• For longer life, use 

alkaline

 batteries.

• Loosen the screw in the battery compartment 

door and remove the door.

• Insert three C (LR14)) 

alkaline

 batteries. 

• Replace the battery compartment door and 

tighten the screw. 

• If this product begins to operate erratically, 

you may need to reset the electronics. Slide 
the power/volume switch off and back on.

• When sounds/motion become faint or stop, 

it’s time for an adult to change the batteries.

• Protect the environment by not 

disposing of this product with 
household waste (2012/19/EU). 
Check your local authority for 
recycling advice and facilities.

1,5V x 3 

C (LR14)

Battery Safety 

Information

In exceptional circumstances, batteries may 
leak fluids that can cause a chemical burn 
injury or ruin your product. To avoid 
battery leakage:

• Do not mix old and new batteries or batteries 

of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).

• Insert batteries as indicated inside the 

battery compartment.

• Remove batteries during long periods of 

non-use. Always remove exhausted batteries 
from the product. Dispose of batteries safely. 
Do not dispose of this product in a fire. The 
batteries inside may explode or leak.

• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent 

type, as recommended.

• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the 

product before charging.

• If removable, rechargeable batteries are 

used, they are only to be charged under 
adult supervision.

Summary of Contents for DHW03

Page 1: ...as no consumer serviceable parts Do not take this toy apart Drop a ball in the top or Drop a ball in the top or bottom of Dino to see bottom of Dino to see it bounce around pop it bounce around pop out the sides or roll out out the sides or roll out Dino s mouth Dino s mouth Roll a ball down Roll a ball down the tail ramp the tail ramp Spin the roller for bouncing Spin the roller for bouncing acti...

Page 2: ...ewdriver Do not over tighten Assembly Upper Body Base 1 2 Snap the upper body onto the base Slide the post through the hole in the upper body Push to snap the bottom of the post into the hole in the base Post M4 5 x 17 mm screw SHOWN ACTUAL SIZE 3 Fit the head onto the body assembly Head ...

Page 3: ...n exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product To avoid battery leakage Do not mix old and new batteries or batteries of different types alkaline standard carbon zinc or rechargeable nickel cadmium Insert batteries as indicated inside the battery compartment Remove batteries during long periods of non use Always remove exhausted bat...

Page 4: ...re is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between th...

Reviews: