6
1,5V x 3
AA (LR6)
Battery Replacement
•
Locate the battery compartment on the back
of the lion.
•
Loosen the screw in the battery compartment
door with a Phillips screwdriver and remove
the door.
•
Remove the exhausted batteries and
dispose properly.
•
Insert three AA (LR6)
alkaline
batteries.
•
Replace the battery compartment door and
tighten the screw. Do not over-tighten.
•
If this product begins to operate erratically, you
may need to reset the electronics. Slide the
power/volume switch off and then back on.
•
When sounds/lights become faint or stop,
it’s time for an adult to change the batteries.
Battery Safety Information
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your toy. To avoid
battery leakage:
•
Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
•
Insert batteries as indicated inside the
battery compartment.
•
Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the toy. Dispose of batteries safely.
Do not dispose of the product in a fire.
The batteries inside may explode or leak.
•
Never short-circuit the battery terminals.
•
Use only batteries of the same or equivalent
type, as recommended.
•
Do not charge non-rechargeable batteries.
•
Remove rechargeable batteries from the toy
before charging.
•
If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
For longer life, use
alkaline
batteries.
•
Protect the environment by not
disposing of this product with
household waste (2012/19/EU).
Check your local authority for
recycling advice and facilities.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) il doit
pouvoir tolérer tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de
compromettre son fonctionnement.