M7873pr-0920
10
PRESS
LI
FT
SOUND BOX BATTERY INSTALLATION
1
• Press the tab under the back edge of the seat and lift to
remove the seat.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removeable, rechargeable batteries are used, they are only to be
charged under adult supervision.
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
ICES-003
• This Class B digital apparatus complies with Canadian ICES-003.
• Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
• Locate the battery compartment near the dash.
• Loosen the screw in the battery compartment door. Remove
the battery compartment door.
• Insert three “AA” (LR6)
alkaline
batteries.
Hint:
We recommend using
alkaline
batteries for longer
battery life.
• Replace the battery compartment door and tighten the screw.
• Fit the tab at the front of the seat into the slot near the sound
button.
“Snap”
the tab at the back of the seat into the slot
near the rear of the vehicle
• If the toy begins to operate erratically, you may need to reset
the electronics. Remove the batteries and replace them.
• When sounds or lights from this toy become faint or stop, it’s
time for an adult to change the batteries.
2
Battery
Compartment Door
Protect the environment by not disposing of this product
with household waste (2002/96/EC). Check your local
authority for recycling advice and facilities (Europe only).
NMB-003
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée seulement aux conditions
suivantes: (1) il ne doit pas produire de brouillage et (2) l’utilisateur
du dispositif doit être prêt à accepter tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
SIDE VIEW
DASH VIEW
"AA" (LR6)
1.5V x 3
