8
Installation Instructions
Step 4
Inlet Hoses
1
Install hoses with the straight end (with filters)
fitted to the faucets.
2
Install elbow ends onto washing machine (inlet
valves are marked on the back of the machine
H=hot, C=cold). Ensure the hot is connected to the
hot, and the cold is connected to the cold.
Note:
If there is a cold water supply only, an inlet valve
cap (available from Fisher & Paykel) MUST be
connected to the hot valve. The cap prevents
water leaking from the hot valve. However, we
recommend this product is connected to both hot
and cold water.
Step 5
Leveling the Washer
1
Unscrew the feet so the machine is
NOT
sitting on
the corner cabinets, then fit the rubber leveling
inserts (refer to diagram 1).
2
Move the washer into its final position. We suggest
a minimum clearance of 1” (25mm) on each side for
ease of installation. (See diagram 2).
3
Turn on water and check hose connections for
leaks. Check that there are no kinks in the hoses.
4
It is IMPORTANT to level the washer to ensure
proper performance during spin.
Adjust the feet by unscrewing/screwing to make
sure the washer is level and cannot rock.
5
Use the walls and adjacent counter tops as a sight
guide to check to see if washer appears level.
Readjust the feet if necessary.
6
Open the lid and check the washer tub to see that
it sits slightly forward of centre. (See diagram 3).
Diagram 3
Correct
adjustment
Incorrect
adjustment
1” (25mm) 1” (25mm)
Diagram 2
1
Faucet
end of
hose
2
Washer
end of
hose
Diagram 1
Adjustable feet
Corner cabinets
Rubber insert
Summary of Contents for WA37T26G
Page 39: ......
