Fisher & Paykel Titan Aerotech OD302EU, Service Manual

Page: 64 / 71

Service Manual 546596A: 302 Series Titan Oven June 2005
64
7.20 Runners
Location: Side walls of oven cavity
Removal
1. Lift the clip at the front of the runners.
2. Lift the front of the runners away from the side wall.
3. Pull the runners out of the oven to release them from the stud hangers at the rear.
Reassembly
ƒ
Refit in reverse manner.
7.21 Oven Door
Removal
1. Open the oven door to its fully open position (90° to oven).
2. Pull the hinge clips on the lower arm of the hinges forward until they lock onto the
upper arm.
3. Raise the door ensuring the clips load the top arm of the hinges.
4. Lift the oven door out of the hinge slots.
Reassembly
1. Place the hinge arms into the hinge slots ensuring they lock into place.
2. Ensure the oven door is opened fully, unlock the upper arm from the hinge clips.
3. Raise the door slightly and ensure the hinge clips are released from the upper arms.
4. Check the door closes and seals correctly.
7.22 Oven Door – Disassembly
To separate door inner and door outer assemblies
1. Remove the door from the oven. (refer to Section 7.21)
2. Lay the door face down on a flat, clean working surface.
3. Remove the four hinge screws on the bottom of the door and the eight retaining
screws down the sides of the door.
4. Separate the inner and outer door assemblies.