2
!
WARNING!
Electric Shock Hazard
Failure to follow this advice may result in
electric shock or death.
• Before carrying out any work on the
electrical section of the appliance, it must be
disconnected from the mains electricity supply.
• Connection to a good ground wiring system is
absolutely essential and mandatory.
• Alterations to the domestic wiring system must
only be made by a qualified electrician
!
WARNING!
Fire Hazard
Failure to follow this advice may result in
overheating, burning, and injury.
• Do not use adapters, reducers, or branching
devices to connect this appliance to the mains
power supply.
!
WARNING!
Cut Hazard
Failure to use caution could result in injury.
• Take care: some edges are sharp.
READ AND SAVE THIS GUIDE
WARNING!
To avoid hazard, follow these instructions carefully before installing or using this appliance.
z
Please make this information available to the person installing the appliance—doing so
could reduce your installation costs.
z
Save these instructions for the local inspectors use.
z
This oven is to be installed and connected to the electricity supply only by an authorized
person.
z
If the installation requires alterations to the domestic electrical system, call a qualified
electrician. The electrician should also check that the socket cable section is suitable for
the electricity drawn by the oven.
z
The oven must be grounded.
z
Installation must comply with your local building and electricity regulations.
z
This appliance must be installed and connected to the mains power supply only by a
suitably qualified person according to these installation instructions and in compliance
with any applicable local building and electricity regulations. Failure to install the
appliance correctly could invalidate any warranty or liability claims.
z
If the power supply cable is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified person in order to avoid a hazard.
z
A circuit breaker is recommended.
z
Do not use adaptors, reducers or branching devices to connect the oven to the mains
electricity supply, as they can cause overheating and burning.
z
Make sure the cavity is completely sealed with no gaps. This is to ensure the oven cooling
system functions correctly.
z
The appliance must not be installed behind a decorative door in order to avoid
overheating.
z
The manufacturer does not accept any responsibility for damage resulting from incorrect
installation.
Electrical requirements
z
Connect oven with copper wire only.
z
Do not cut the conduit.
z
A U.L. listed conduit connector must be provided at the junction box.
z
Do not ground to a gas pipe.
z
Do not have a fuse in the grounding or neutral circuit.
z
Fuse both sides of the line.
z
A time delay fuse or circuit breaker is recommended. If using a time delay fuse, then
fuse both sides of the line.
z
Flexible armored cable from the appliance should be connected directly to the junction
box.
z
Connect directly to the fused disconnect (or circuit breaker box) through flexible,
armored or non-metallic sheathed, copper cable (with grounding wire).
z
If codes permit and a separate grounding wire is used, it is recommended that a qualified
electrician determine that the grounding path and wire gauge are in accordance with
local codes.
SAFETY AND WARNINGS
IMPORTANT SAFETY INSTRUCTIONS