Lubrication of the Gas Taps
A qualified technician must lubricate the gas taps.
•
All intervention regarding installation maintenance and conversion of the appliance must be
fulfilled with original factory parts.
•
The manufacturer declines any liability if these correct parts are not used.
Connecting the Feeder Cable
To connect the feeder cable to the cooker:
• Remove the screws securing the cover “A” on the rear of the cooker.
• Feed the supply cable through the cable clamp “D”. See the ‘Feeder cable section’ following for the correct size
for the cable.
• Connect the wires to the terminal
• block “B” as shown in the diagram; or connect the phase wires to the terminal block “B” and the earth wire to the
terminal PE as shown.
• Take up any slack in the cable and secure with the cable clamp “D”.
• Replace the cover “A”.
The earth conductor must be left about 3 cm longer than the others.
Updated: Fri, 10 Apr 2020 07:18:41 GMT
Powered by
13