Fisher & Paykel EB76PSX1, Installation Manual

Page: 8 / 12

8
Before placing the coffee maker into the cavity:
z
Route the power cord into the back of the cavity and plug it in to the switched socket.
z
The switched socket should be in an easily accessible area within 900mm of the centre rear
of the product.
Note: All electrical work may only be carried out by suitably qualified and competent persons
in accordance with national and local safety regulations.
This coffee maker must be grounded.
Power requirements
POWER HZ VOLTAGE (V) PRESSURE
1350 W 50-60 Hz 220-240 V 1.5MPa
ATTACH THE TRIM TO THE COFFEE MAKER ELECTRICAL CONNECTION
2
1
Before installing the coffee maker in the cabinetry, the side trims and lower trim need to
be attached.
Align the side trims on either side of
the coffee maker, using the locating
tabs and corresponding slots.
Attach the side trims using the hex
key and 6 of the screws provided.
Do not over-tighten.
3
Attach the 4 remaining screws to the
base of the side trims.
Only screw halfway in so the lower
trim can be mounted.
Slot the lower trim onto the screws,
using the locating slots.
Ensure the screws are seated as far
as possible into the the locating slots.
Pull the side trims forward so the
lower trim is flush with the back
edges.
Tighten the screws to secure.
4
1
2
1
2
3