To clean the filter:
1. Open the dryer door.
2. Remove the lint filter by pulling it up and out of the filter slot.
Open it out and wipe the surface clean with your hand.
3. Close the lint filter and place it back in the opening. Ensure
the filter is fitted correctly back in place before operating the
dryer.
Lint filter
If the lint filter becomes damaged, contact your Fisher & Paykel trained and supported
service technician to arrange getting a new filter. Do not operate your dryer with a
damaged lint filter or without the filter in place, as this will cause damage to your dryer.
Emptying the water collection tank:
During the drying cycle steam condenses into water and is collected in the
water tank, located at the top left of the dryer. It is important to empty the
water tank after every load.
There is an indicator light that will illuminate when the water tank needs
emptying. A user warning will also be displayed on the screen (refer to the
'
' section). If the water tank becomes full during
operation, the dryer will go into ‘Cool’ mode for several minutes, then
pause and beep to alert you. Empty the tank and touch
Updated: Fri, 14 Feb 2020 06:11:37 GMT
Powered by
2
