19
• Remove rear panel as per sec. 7.3
• Remove screws holding element panel and remove the wiring from the element and thermostats
• The belt can now be removed by tilting the motor within the cradle so as to take the tension off the
belt and rolling it off the motor pulley
Reassemble
in the reverse order
Note:
The pulley and small belt are not available as a spare part at this stage and the motor must be
replaced
7.10 Removal of belt
7.11 Removal of door assembly
7.12 Removal of door switch
7.13 Removal of power module
7.14 Removal of elements
• Remove the two screws securing the hinge to the cabinet and lift the door upwards and away
Reassemble
in the reverse order
• Remove top panel as per sec. 7.2
• Remove two screws on front panel of dryer and lift switch clear of front drum support
Reassemble
in the reverse order
• Remove top panel as per sec. 7.2
• Remove the 2 screws securing the support
• Remove the 3 screws from the power module
Reassemble
in the reverse order
• Remove rear panel and wiring from the element and thermostats
• Remove the nut from the flange shaft and 4 screws securing the element carrier to the cabinet
• Remove the 4 element supports and elements
Reassemble
in the reverse order
Note:
Replace both elements at once even if only one is faulty
