26
DRYING CYCLE OPTIONS
Delay Start (DE5060M only)
The ‘Delay Start’ option enables you to delay the start of the drying cycle from between
5 minutes and 12 hours. Times you can select are 5 min, 15 min, 30 min, 1 hour, then
hourly up to 12 hours. This can be useful to time your drying to finish when you arrive
home from work, or to start when power rates are lower.
To programme a ‘Delay Start’, simply press the button to cycle through the delay
start times available. To decrease or turn off ‘Delay Start’ continue to cycle through the
time options. Press to confirm your selection and start the countdown. Once the
‘Delay Start’ has been started, the time will count down on the digital display in one
minute increments, the ‘Delay Start’ light will flash and the light will stop flashing and
remain lit.
The ‘Delay Start’ option is not available on the ‘Time Dry’ cycle.
IMPORTANT!
We suggest that you avoid using ‘Delay Start’ for damp, non-colourfast items as this
may cause dye run to occur.
Customising dryer cycles (DE5060M only)
After using your dryer a few times you may discover there are some drying options you
prefer for some cycles.
You can programme your dryer to remember the drying options you prefer for each
drying cycle. For instance, you may want to set the ‘Everyday’ cycle to a lower drying
temperature.
To customise a cycle:
1
Press ‘POWER’
to turn the dryer on.
2
Select the cycle you wish to customise.
3
Press and hold any of the drying options buttons for 3 seconds. The lights will flash
on and off and the display will show
to indicate that the dryer is in cycle
adjustment mode.
4
Select the drying options you prefer by pressing the relevant option button.
5
Press and hold for 3 seconds to save the selected settings. The dryer will then beep to
indicate your customised cycle has been saved.
Factory reset
You can reset your dryer to the default settings it left the factory with:
1
Press and hold the ‘Keylock’ and ‘Delicate’ buttons together for three seconds.
3
Your dryer will now be reset to the default settings.
