Fisher & Paykel AWF 60 MD, User Manual

Page: 8 / 24

Water Supply
• Hot water temperature should not exceed 75˚C. Temperatures above this may the machine to fault or
cause damage to the machine
• If you have an uncontrolled water heating source (eg a wet-back or solar heating system) you should
fit a Safe Valve. This will ensure the hot water temperature remains within safe limits.
• Inlet water pressure: Maximum 1 MPa (150 psi), Minimum 34 Pa (5 psi)
• Inlet water flow rate: Minimum 3 litres/minute
Inlet Hoses
1) Connect the straight ends of the inlet hoses to the taps. There are washers fitted in both ends.
2) Connect the elbow ends of the inlet hoses to the inlet valves on the back of the machine. The cold inlet
valve is marked in blue, while the hot inlet valve is marked in red.
Cold Supply Only :
If you only have a cold water supply, an inlet valve cap (blanking cap) MUST be connected to the hot inlet
valve. The cap prevents water leaking out of the hot inlet valve. The cap is supplied in the same bag as
the inlet water hoses.
4. Adjust feet
In order for quiet and stable operation, the machine should be placed properly and levelled on its feet.
Your machine comes with two adjustable feet. If the machine is unstable, loosen the plastic counternut
and screw or unscrew the adjustable foot until the machine is levelled perfectly. After positioning, tighten
the counternut for stability.
7
3. Position the washing machine
• Move the appliance without lifting it by the worktop
• Install the appliance on a solid and level floor
surface, preferably in a corner of the room
5. Connecting water inlet hoses
• Connect the water supply inlet hose in accordance with regulations of your local water company