Fisher & Paykel 93275, Installation Manual/User Manual

Page: 35 / 82

31
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES WHAT TO DO
Linting Lint filter not cleaned or
replaced. Ensure the lint filter is cleaned after
every cycle and replaced correctly.
Refer to page 27.
Loads not sorted correctly. Dry lint givers separately from
lint receivers. Dry similar colours
together eg light coloured items
with light coloured items, dark
items with dark items. Refer to page
19.
Clothes over dried. Over drying clothes in the dryer can
cause them to attract lint. Use an
auto sensing cycle or ensure you
check your load if using the time
dry cycles to avoid over drying.
Refer to pages 22 and 23.
New items have been dried
in the dryer recently.
New towels or flannelette
sheets can leave lint in the
dryer, which may be picked
up by subsequent loads. Clean the lint filter and use ‘Air Dry’
cycle to clear any remaining lint
from the dryer.
Fabric damage Catching on metal part on
items in the load. Fasten zips and other clasps before
placing items in the dryer.
Items not separated or dried
on an appropriate cycle for
the fabric type. Dry similar items together. Ensure an
appropriate cycle is selected. Refer
to pages 19, 22 and 23.
Items fell off the rack when
using ‘Rack Dry’. Ensure the rack is installed correctly
(refer to page 21) and only one
or two garments are placed on the
rack at a time.
‘Dry Temp’ or ‘Dryness
Level’ selected not
appropriate for the fabric
type. Ensure the ‘Dry Temp’ and ‘Dryness
Level’ selected is appropriate for
the fabric type. Refer to the items
care label. Refer to pages 22 and
23.
Used a ‘Time Dry’ cycle and
did not monitor the dryness
of clothes during the cycle. Ensure that clothes are checked for
dryness during the cycle when using
the timed programmes to avoid
over drying. Refer to pages 22
and 23.
Instructions on care label
not followed. Follow the instructions on the care
label of the items.