Fisher & Paykel 81094-A, Manual

Page: 60 / 76

36
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE WHAT TO DO
Drawer will
not open (no
beeping, no wash
underway)
Childlock feature is on. Turn the Childlock off. See your
Quickstart guide for instructions.
Closed drawer auto lock
is on. Press any button and open drawer
within 30 seconds.
Power failure
during cycle
Power outage in your
home or area. Wait until power resumes, cycle will
restart in same part of wash program.
Continuous
beeping with
A
/
F
code in
display
A fault has occurred. Refer to section ‘If there is a fault’.
Intermittent
beeping Dishwasher is in pause
mode.
Close the dishwasher and press the
button to resume the program.
Dishwasher will
not start Power supply is not
connected. Connect the power supply.
The drawer is not closed
properly. Ensure the drawer is firmly closed.
Keylock or Childlock
feature is on. Turn the Keylock or Childlock off. See
your Quickstart guide for instructions.
button not pressed. Press the button.
Dishdrawer is in
“Showroom mode”. Contact Customer Care.
Fan noise
coming from the
dishwasher after a
wash program has
finished This is normal. The drying
fan continues to run for a
set period of time after a
program has finished to
assist with drying. No action required. The fan will
automatically stop after the set time is
over, or when the drawer is opened. In
some cases, the fan may resume when
the drawer is closed again.
Fan noise starts
up when I close
the drawer, even
though I didn’t
start a new wash This is normal. In some
cases, the drying fan will
run whenever the drawer
is closed for a set period
of time after a program
has finished. No action required. The fan will
automatically stop after the set time is
over.
No powdered
detergent
dispensed
Detergent dispenser was
wet when loaded. Clean the dispenser and ensure it is dry
before adding detergent.