FB23083 & FB23084
Jeep® JL Wrangler
Step sliders - 4DR
(FB23083)
and 2DR
(FB23084)
2
2308300
3)
INSTALL PASSENGER SIDE STEP SLIDER
Slip the flat bracket of the step slider between the
frame and crossbar.
Slip the other mount(s) above the body mount
washers and onto the factory studs.
4)
REINSTALL ALL OEM HARDWARE
NOTE: If you choose to install the optional
hardware, proceed to step 5) prior to fully installing
all hardware. Tighten a few nuts to hold the slider
in place while marking the hole location.
Secure the step slider by reinstalling the OEM
hardware.
5)
INSTALL OPTIONAL MOUNTING HARDWARE
NOTE: Drilling of the frame rail is required to install
the optional hardware on the passenger side only.
The driver side frame has an existing hole that can
be utilized.
Nutplates and bolts are supplied to help remove
some flex in the step sliders, especially the 2DR
version. If you choose to install this optional
hardware, mark the center of the hole in the bracket
using a white paint pen.
Remove the step slider and drill the marked location
with a 7/16” drill bit.
Use a smaller drill bit and step
up in size if necessary. A centerpunch is also
recommended to aid in starting the hole.
Reinstall the slider and secure all OEM hardware.
Insert the supplied nutplate into the large round hole
in the frame at the front of the installed step slider.
Work the plate toward the drilled or OEM hole in the
frame that lines up with your slider hole. Install the
bolt with a flat washer and lock washer and secure.