FISCHER FISCHERSCOPE X-RAY XDLM 231, Operator'S Manual

Page: 26 / 236

24 FISCHERSCOPE ® X-RAY
Set up
3.4 Establishing Connections
Check the supply voltage before connecting the instrument to the voltage supply. The nominal line
voltage is shown on the name plate and is either 110 V or 230 V (AC).
Figure 3.1: Connectors and switches at the right side of the instrument
Establish the following connections
1. USB: The USB cable has two different connectors: a quadratic one and a flat one. Connect the
quadratic connector to the instrument and the flat connector to a USB 2 socket at the PC. If no
free USB 2 socket is available, connect the mouse or the keyboard to a USB 3 socket.
The following table helps to distinguish between USB 2 and USB 3 sockets. Please note that not
all characteristics need to apply, e.g. a USB 3 socket may also be black.
ATTENTION Wrong line voltage
Connecting the instrument to the wrong voltage can damage the instrument.
►
Make sure that the voltage, shown on the name plate of the instrument,
equals to your line voltage.
ATTENTION Communication Breakdown Instrument – PC
If you connect the USB cable of the instrument with a USB 3 socket at the PC,
the communication between Instrument and WinFTM can be disturbed.
►
Connect the USB cable of the instrument with a USB 2 socket and not with
a USB 3 socket at the PC.
1 2
3 4 5
1 Main switch
2 Video signal line socket, to PC vid-
eo socket
3 USB interface, to PC
4 Main fuse
5 Voltage supply for instrument