ALARM TRIGGER EVENT
LED FLASHES
Door, Hood, Trunk, or Ignition On triggered
2, Pause, Then Repeat
Full triggered shock sensor
3, Pause, Then Repeat
Optional sensor triggered
4, Pause, Then Repeat
Panic Mode
5, Pause, Then Repeat
PARKING LIGHT FLASHES
REMOTE START ERROR
3 then 1
1: Motor running
3 then 2
2: Key in ignition on position
3 then 3
3: Door open
(manual transmission only)
3 then 4
4: Trunk open
3 then 5
5: Foot brake on
3 then 6
6: Hood open
3 then 7
7: Reservation off
(manual transmission only)
3 then 8
8: Tach or voltage sensing failure
3 then 9
9: FT-DAS sensor shutdown
3 then 10
10: System is in Valet Mode
ALARM LED CODES
QUICK START CARD
RF-1WR3R-FM
START ERROR CODES
If you have an alarm and optional LED(s) installed, it will flash once
a second if armed. If your alarm is triggered then the LED(s) will flash
more than once until it is disarmed. See the table below for what
each LED code represents.
To reprogram your remote first cycle the key in the ignition 5 times
within 7 seconds. Parking lights will flash. After that tap the Lock
button on your remote. Repeat for any additional remotes. If you
receive two parking light flashes, your system has exited remote
programming mode and you must retry.
Register online at www.compustar.com within 10 days of purchase to
activate your new remote’s warranty.
Questions/comments? Contact us at 888-820-3690 from 8
AM to 5 PM PST. Also please visit www.compustar.com for a
complete user’s manual.
1W1B_QuickCard line.indd 2
2013/6/6 9:28:50
