9 By Firstech, LLC
By Firstech, LLC 8
The system can be configured to automatically lock and arm the vehicle 30 seconds after closing the last door. Place the system in passive by
taping buttons simultaneously for a half (0.5) second. The vehicle will flash the lights once and/or siren chirp once to indicate the
system is in passive lock and arming mode. Tap the same buttons again to turn passive mode off. The parking lights will flash twice and/or siren
chirp twice to show it is off.
As an indicator that the vehicle is going to passively lock and arm, the remote and siren will chirp once and the parking lights will flash once at both 10 and 20
seconds prior to passively locking and arming. If you want the system to passively arm and not lock, ask your local dealer to turn Option 1-8 to setting III.
p @lOa
General System Functions
Only available with CS600-S / AR600-S remote start only system
Hold the button for 2.5 seconds to remote start an automatic transmission vehicle. If you are in range and if the vehicle is ready to remote start, the vehicle
parking lights will flash once.
If you are in range, the parking lights on the vehicle will flash three times followed by a certain number after that, there is a remote start error. Refer to the
“remote start error diagnostic” for details.
Upon receiving confirmation that your vehicle is running, the parking lights will light solid. The remote start run time can be set for 3, 15, 25, or 45 minutes.
This should be set at the time of installation. If not ask your place of purchase to adjust the option if you would like a run-time other than the default 15 minutes.
IMPORTANT: The vehicle’s key must be inserted into the ignition and turned to the “on” position prior to driving your vehicle. If the foot brake is depressed
prior to the key being in the “on” position, the vehicle will shut off.
a@t@r @@f
General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The four button configuration allows for keyless entry, trunk
release, and/or remote start functionality. These commands may require additional parts and labor. Please check with your place of purchase for more
information.
Sending Commands
When in range, and a button has been pressed, the remote bright blue LED will illuminate and vehicle’s parking lights will flash. For example, to send a remote
start command from the 600R, hold down the Button for 2.5 seconds. The remote bright blue LED will come on solid and then flash.
Only available with CS600-A alarm only system. An alarm will trigger if a door, trunk, or option trigger is opened. It will also trigger if the shock sensor detects
an impact. In the event that an alarm trigger is activated you can silence the siren by tapping the
or buttons.
a@t
Tap the button for 0.5 second to lock/arm your vehicle. Tap the button to unlock/disarm your vehicle. The remote bright blue
LED will flash indicating the signal has been sent to the vehicle. This feature is optional and may require additional programming and/or
installation. Please check with your place of purchase for details.
a @lOa@@uOd
