First Office STAKS HA Instruction Sheet Download Page 1

Page: 1 / 9

PEDESTAL PLACEMENT

ASSEMBLY INSTRUCTIONS

STAKS HA Benching

Place cabinets in final desired location. Check for alignment and make
sure cabinets are square.

Cabinets should not be moved after assembly

is complete.

Remove front panels from cabinets.

INSTRUCTION SHEET #1830828

PART #2584INS

Position cross bars and attach with #8 x 1

" pan head screws

(HK-103). Cross bars should be centered on double sided configuration

and 3" from the back of single sided configuration.

90 DEGREES

ALIGN CABINET

CENTERED

INSET 3"

#8 X 1

PAN HEAD

SINGLE SIDED

DOUBLE SIDED

ATTACH CROSS BARS

ASSEMBLY INSTRUCTIONS

Summary of Contents for STAKS HA

Page 2: ...ng 6 M6 x 12MM socket head cap screws INSTRUCTION SHEET 1830828 PART 2584INS 1 Align holes in control box with pre drilled holes on under side of work surface 2 Attach using 2 8 x 2 pan head screws HK 92 ATTACH CONTROL BOX ASSEMBLY INSTRUCTIONS M6 X 12M SOCKET HEAD CAP SCREWS 8 X 2 PAN HEAD SCREWS ...

Page 4: ...g 1 Plug mains cable into 120V outlet to power up the system 2 Press the up arrow on the control panel and raise the work surface to top position 3 Screw in remaining 12 x 1 truss head screws that were inaccessable before INSTRUCTION SHEET 1830828 PART 2584INS ...

Page 5: ...y screwing cap to bracket using 2 6 32 x 5 8 phillips flat head bolts 2 Slide brackets on to back edge of work surface 3 Center modesty panel on work surface end to end and secure by tightening set screws INSTRUCTION SHEET 1830828 PART 2584INS 6 32 X 5 8 PHILLIPS FLAT HEAD BOLT SET SCREW ...

Page 6: ...desty pins to cross rail by inserting pin into pre drilled hole and secure with 2 8 x 1 flat head screws per pin HK 73 2 Align holes in bottom of modesty panel with pins and slide down until seated on rail INSTRUCTION SHEET 1830828 PART 2584INS 8 X 1 FLAT HEAD SCREW MODESTY PIN ...