First Degree Fitness FLUID E750, User Manual

Page: 10 / 24

10
Assembly Instructions
STEP 3
Assembly Upper Seat Frame and Lower Seat Frame
Upper Seat Frame[3] onto Main Frame[1] and secure using 1x
M10x25mm Bolt[16],1x M10 Nyloc Nut[20], 2xM10 Washers
[18], M10 Plastic Washer[19] and L-pin[6].
Note: Tighten the
M10x25mm Bolt, Washers
and Nyloc until lightly snug
only. Over-tightening will
prevent the seat from
rotating. Use the L-pin to
tighten the Upper Seat
Frame once rotated into
place.
STEP 4
Assembly Right Crank Pedal
12
Secure Right Crank Pedal[8] onto Crank arm. The Pedal
threads have a blue coating which will feel very tight when
threaded onto the crank arm. This is a type of thread locker,
and once in contact with the crank arm threads will activate
in approximately 15minutes.
2
REQUIRED
Right Crank Pedal [8]
CAUTION
Extreme over-tightening
could damage the aluminum
threads on the crank arm
Note: Allow 15 minutes
for the thread-locker to
activate before first time
use.
Check pedal tightness on a
regular basis and tighten
as needed with a 15mm
wrench.
Right Crank Pedal
M10x25mm Bolt
M10 Washer
Before installing
the Upper Seat
Frame onto the
Lower, use the
supplied grease
and apply liberally
between the two
sliding surfaces
L-Pin
M10 Plastic Washer
lubricating grease
M10 Nylock Nut
REQUIRED
Main Frame [1]
Upper Seat Frame [3]
L– Pin [6]
M10 x 25mm Blots [16]
2 x M10 Washers [18]
M10 Plastic Washers [19]
M10 Nyloc Nuts [20]