10
Assembly Instructions
Tighten frame
bolts securely
once Rower is
standing.
Using M8x20mm Bolts[8] , M8 Washer[6]
into Rear Brace[4].
Once the Bungee cord is attached to the Rear
Brace, tighten the bolts holding the Footboard,
the Mainframe to Side Rail Bolts as they are
easier to access from the vertical position.
Lower the Fluid Rower back to the horizontal
position and test for proper bungee recoil.
Check Seat Rollers/Runners for dirt or debris
before sitting on the Rower Seat. Small objects
captured between the Seat Rollers and Runners
can damage the Wheels or running surface.
Check Runners for debris prior to each use and
clean regularly.
Note: The Rower Frame bolts require periodic
checking for tightness. Do this at the end of
the first month of use and again after every
12 months
Choose a suitable location when standing the
Rower for storage.
Install supplied 2x AA Duracell battery and
check computer function. Details regarding
can be found in the Computer section of this
manual.
Choose a flat, level surface on which to use your
Rower, to avoid rocking and potential premature
wear.
STEP 4
Completing The Rower Assembly
