23
Fault
Probable Cause
Solution
Water changes color or
becomes cloudy.
Rower is in direct
sunlight or has not
had water treatment.
Local tap water is of
poor quality.
Change rower location to reduce
direct exposure to sunlight. Add
water treatment or change tank
water as directed in the water
treatment section of this manual.
Consider using distilled water to
refill tank.
Rower Belt slipping off
belt/ bungee pulley.
Bungee not under
enough tension.
Recoil not strong
enough
Tighten bungee cord following
the instructions in "reattaching
the rower belt" section of this
manual.
Inconsistent readings
on the Rower
Computer for 500meter
split time and SPM
(strokes per minute).
Sensor gap
Faulty Sensor
Sensor has moved out
of position
Wiring harness
Use the back cover of the computer
as a “Gap tool” to check the gap
between sensor head and Magnetic
ring, or see if the Sensor head has
moved out of position.
Please contact your nearest FDF
customer service center for details
The Rower Computer
does not illuminate
after battery
installation.
Batteries installed
incorrectly or need
replacing.
Replace/reinstall batteries in
correct position and try again.
If the LCD screen fails to
illuminate, try rotating the
batteries slightly in the computer.
If this fails, contact your local
service center.
The Rower Computer
screen illuminates, but
does not register when
rowing.
Loose or failed
connection.
Sensor gap too wide
Check that the computer lead is
connected properly. If it is
connected then contact your local
service center. Check Sensor gap.
Troubleshooting
