Manual Part No: 930158-01
MD Electric Range
- 19 –
Manual Rev No: 1
INSTALLATION
Important
This appliance
MUST
be installed by a competent person in accordance with these and any other relevant
regulations.
The installation wiring
MUST
comply with the latest I.E.E. Regulations.
WARNING:
THIS APPLIANCE MUST BE ELECTRICALLY EARTHED
.
Before Installation
Before commencing installation, remove all packaging materials from the appliance. It is suggested that
any protective film adhering to the stainless steel panels should be left on until installation is completed.
BUT THIS MUST BE REMOVED BEFORE COMMISSIONING OR OPERATING THE APPLIANCE.
Check the appliance Data Plate (fitted to the back panel), to ensure that the appliance is suitable for the
electricity supply available.
Ensure that the floor upon which the appliance is to stand is level and capable of adequately supporting
the weight of the appliance.
TO COMPENSATE FOR SOME UNEVENNESS OF THE FLOOR, THE
APPLIANCE FEET ARE ADJUSTABLE.
THE FLOOR MUST BE FIRE PROOF
. If it is not, or if any adjacent wall or surface is made of a combustible
material, then the installer must ensure that the requirements of the
LOCAL FIRE REGULATIONS
are
observed.
Positioning
Place the appliance in position allowing a minimum of 150mm (6”) at the rear and at least
150mm (6”) between the sides of the appliance and any adjacent wall. If the appliance is being suited
please refer to the separate instructions. The minimum distance between the top of the appliance and
any overshelf or ceiling constructed of a combustible material must be 1525mm.
It is recommended that the appliance be sited below a ventilating hood, one preferably connected to an
extractor system incorporating a grease filter.
Ensure that the appliance is level in two places - front to rear and side to side. To check the level it is
recommended that a spirit level be placed on the oven shelf.
