6
5
reMovinG tHe SaFetY interLocK Screw
batterY inStaLLation
1
Locate the 9V Alkaline
Battery in the plastic bag.
2
Remove the Phillips head screw
from the battery cover located
on the bottom of the keypad.
3
Connect the battery and
gently insert the battery
up inside the keypad and
replace the battery cover.
4
Re-install the Phillips head
screw in the battery cover.
DO NOT OVER TIGHTEN!
IMPORTANT: Your safe may have a “Door Lock Override Device” installed.
This device is to prohibit the lock from locking and it must
be removed before the safe can be used properly.
1
Locate the handle spoke in the plastic bag and remove the
protective cover.
Screw in the handle spoke at the bottom of the handle hub.
2
Locate the Allen Wrench and the black cap in the plastic bag.
3
Locate the screw in the center of the Consumer
Warning label on the side of the door.
4
Loosen the screw with the Allen Wrench.
5
After the screw is removed, discard it and cover the hole with the black cap.
important
keypad cannot be removed from door.
Warning
The Safety Interlock Screw must be removed before
BATTERY INSTALLATION AND PROGRAMMING THE LOCk.
