Contents
1041864
Important:
If you are missing parts, have difficulty programming your safe or have any other questions pertaining
to its proper use and care, DO NOT RETURN your safe to the store. Please contact Customer Service Team at
1-800-323-9005. To assist us in serving you, please have the model number, serial number, and date of
purchase available when calling.
2
2
1
3
4
5
2
2
1
3
4
5
1041864
2
2
1
3
4
5
Initial Setup
Installing the Battery
1. To remove keypad, the locking tab must be pressed and held to the side (Left) while you twist the keypad counter
clockwise (to remove it). Carefully hold the battery connecting cap while attaching the 9V alkaline battery
(included). Then rotate clockwise the cover back in place. Be sure the wires are pushed back into the safe to avoid
any pinched wires.
2. Repeat above steps for battery replacement.
Installation of Safe Door Handle
Take the three metal spokes and turn counterclockwise into the hub found on the door of the safe.
Opening the Safe for the First Time
After installing the battery, to open an electronic lock the first time, press the following numbers/symbols on the
electronic keypad in this order:
1 - 5 - 9 - #
These numbers are preset.
NOTE: You should change the entry code as soon as possible after opening the safe to insure proper security.
After you have entered the factory code, you will need to turn the handle clockwise to open the door. You will have
5 seconds to turn the handle before the locking mechanism is reactivated.
Important:
The override key is used to gain access to the safe if the digital lock fails to operate.
This key should be stored in a secure place away from your safe.
Clean the battery contacts in the battery compartment and on the battery before installing a new battery.
Important:
1
Battery System: Alkaline
Designation: 9V
Quantity required/Included: 1
9V
NOTE:
1. When changing the battery, always hold the battery
connecting cap while disconnecting or attaching the
battery. Do not pull on the wires. Doing this could cause
the power supply to become disconnected from the lock.
2. When the battery runs out, the red light will flash when
you press any button on the keypad. Replace the battery
when the red light flashes.
2
ABC
3
DEF
1
5
JKL
6
MNO
4
GHI
8
TUV
9
WXY
7
PRS
0
*
#
2
2
1
3
4
5
2
2
1
3
4
5
2
2
1
3
4
5
Safe Identification Record
Digital Passcode Record -
Model 2484D / 2484DE
Your Passcode must be at least 3 digits and no more than 8 digits followed
by the letter # or *
Digital Passcode Record -
Model 2583D / 2583DE / 2584D / 2584DE / 2743D / 2743DE
Your Passcode must be at least 3 digits and no more than 8 digits followed
by the # sign.
Model Number
Serial Number
Key Number
#
*
#
6741DF, 6742DF
Digital Passcode Record
Model 1041864
1
One yellow light
flash with one
audible “beep”
If installed correctly:
Flash
Beep
2
ABC
3
DEF
1
5
JKL
6
MNO
4
GHI
8
TUV
9
WXY
7
PRS
0
*
#
Override Key Use
Insert key and turn clockwise and hold.
Rotate handle clockwise then pull door open.
Important:
If key will not turn please
note that there will be some
resistance then you have to
push the key further in to
properly engage key to turn
clockwise.
If the handle will not rotate
clockwise after the key is
turned, then rotate the handle
slightly counterclockwise
until it stops, then rotate
clockwise again to open.
Turn lock cover as shown.
2
ABC
3
DEF
1
5
JKL
6
MNO
4
GHI
8
TUV
9
WXY
7
PRS
0
*
#
