III.
Install SeriTek/6G2+2 in ThunderTek/PX
1.
Mount Rubber Feet in suggested locations.
2.
Remove Top Housing:
Unscrew three screws on each side of
ThunderTek/PX
3. Loosen screw and remove PCI Mounting Tab
4.
Screw Posts to Bottom Chassis
- Insert screw (Flat Head) from bottom of chassis
- Tighten Post: Use finger to press on Flat Head
Screw while other hand turns Post until tight
- Repeat the same steps for the 2nd Post
5. Install SeriTek/6G2+2 Card:
- Install drive(s) on SeriTek/6G2+2
- Insert adapter bracket into PCIe Tab Slot and
firmly push Gold Teeth into PCIe slot
- Gently press PCIe adapter to verify card is
seated properly in PCIe slot
Note:
Hold PCIe card by its edges only. Do NOT touch
Gold Teeth or any components on the card.
- Screw SeriTek/6G2+2 to Posts
6. Reinstall PCI Mounting Tab
- Position & Place PCI Mounting Tab into
housing. Verify both holes align
- Tighten screw to secure PCI Mounting Tab to
housing
- Tighten screw to secure Card to Mounting Tab
7. Reinstall the Top Housing
-
Attach Top Cover and secure with six screws
1
1
1
1
2
3
2
2
Mounting Tab
Tighten Screw to
Secure Tab
Tighten Screw to
Secure Adapter
6
Flat Head
Screw
4
5
Card Firmly Seated
Secure PCBA
