Page 21
English Customer Service: 1-844-FIRMAN1
4. Fully open the LPG
cylinder knob
.
5. Turn the fuel selector switch to “
LPG
” position.
3. Connect the regulator to both LPG cylinder and
generator.
NOTE:
When the fuel selector switch is turned
to the “
LPG”
position, the indicator light will
become
RED
up to
4 minutes
(before goes off).
Starting the engine successfully during these
4 minutes
will turn the indicator light
GREEN
.
6. Disconnect all electrical loads from the
generator. Never start or stop the generator
with electrical devices plugged in or turned
on.
7. Move choke lever located on engine to “
START
”
position.
NOTE
:
Do
not
place
the
LPG
cylinder
in
the
path
of
muffler
outlet
.
9.Move the choke lever to the “
RUN
” position.
11. Allow generator to run at no load for few
minutes upon each initial start-up to permit
engine and generator to stablize.
8.
PULL TO-PRIME:
-
Pull the starter cord 1-2 times. Pull slowly until
resistance if felt and then pull rapidly.
10.
PULL TO RUN:
-
-
Pull the starter cord slowly until resistance if felt
and pull rapidly to run the unit.
REMINDER:
MUST HAVE
SOLID RED INDICATOR
LIGHT
TO BE ABLE TO START THE GENERATOR.
THE GENERATOR CANNOT BE STARTED DURING
BATTERY POWER SAVING MODE
UNLESS
If the engine fails to start in 1-2 pulls with choke in the
“
RUN
” position, then move choke lever to “
START
”
position and repeat the “
PULL-TO-PRIME
” step.
1-2 Times
