STARTING THE ENGINE
5. OPERATING PROCEDURES
(a) Check the AC circuit breaker. Make sure the
circuit breaker is in
the ON position.
(b) Open the fuel switch to ON position.
(c)Set the choke lever to the "CHOKE”
(arrow mark)position.
Not necessary if the engine is warm.
Page 13
(d) Turn the engine switch to the
“ON” position.
ON
OFF
(
e) Pull the starter handle slowly until
resistance is felt. This is the "Compression"
point.Return the handle to its original
position and pull swiftly. Do not fully pull
out the rope. After starting, allow the starter
return to its original position while still
holding the handle. If the engine fails to
start after several attempts, repeat above
procedures with choke lever returned
"CHOKE
" position.
(f) Move the choke lever to the “Run” position.
Circuit
Breaker
ON
OFF
