11. Connect the Control Box, Handset, Power
Cord, and Cables. Use the Cable Ties to secure
the cables so they don’t sag.
12. Plug the Power Cord into a 110V outlet.
Make sure no obstacles are in the desk’s path.
Make sure the desktop is
not touching any walls.
Make sure all cords are the correct length
to accomodate the change in height.
The Handset will display
IMPORTANT:
You must
RESET
the desk prior to use.
13.
RESET PROCEDURE:
Push and hold the
DOWN
button on the Hand
-
set until the desk reaches its lowest height,
slightly rises, and stops. Release the
DOWN
button. The desk is now ready to use.
14. To move the desk up, press and hold the
UP
button. Release the
UP
button to stop. To move
the desk down, press and hold the
DOWN
but
-
ton. Release the
DOWN
button to stop.
15. To program up to three preset heights: press
and hold the
UP/DOWN
button to your desired
height, then press “
S
” followed by a number
(
1-3
).
CAUTION: Once a preset button is pushed, the
desk will move to the programmed height. To
stop the desk, press the
UP/DOWN
button.
TROUBLE SHOOTING
www.firgelliauto.com
1. If the lifting columns are at different heights
you need to reset the desk lift. Follow the proce
-
dure outlined in step 13.
2. If the error message
is displayed, confirm that all wired connections
are secure (legs to cables, cables to control box).
Then perform the reset procedure outlined in
step 13.
3. If the Handset displays the Control
Box’s temperature is above 75 and needs to cool.
Leave the desk for 20 minutes, or if urgent un
-
plug the power cord, wait 10 seconds then plug
the power cord in again.
4. If a lifting column has been loaded with >90kg,
the overload protection error message will show
Reduce the load and after 30 seconds it
will recover. If not, reset the desk.
page 5
