HotPort 5020-M node installation
19
Opening the mount bracket
HotPort 5020-M nodes come with an assembled two-piece mount bracket. The
next picture shows a radio-side of a node and the assembled bracket. Two captive
screws are on each side of the device.
Captive screws
The next picture shows the bracket pieces and orientation to the node. The
mount bracket has multiple holes and slots, so you can use bolts, straps, or other
materials to attach the node to a surface.
Image A shows the side of the plate to which the chassis is attached. Image B
shows the mount bracket on which you hang the node. This bracket attaches to a
pole or other surface.
The mount kit includes extra nuts and bolts.
Required tools: #2 Phillips screwdriver
To open the mount bracket so you can attach the node to a wall or pole:
1.
Use the Phillips screwdriver to loosen the four captive screws (two on each
side).
