Fire Stone Home Products • Legacy Gas Grill • Rev. D
5
Beware of Spiders
Safety Instructions
• If the hose appears damaged do not use gas grill. Call
your dealer for a factory authorized replacement hose.
• Keep the gas regulator hose away from hot grill surfac
-
es and dripping grease. Avoid unnecessary twisting of
hose. Visually inspect hose prior to each use for cuts,
cracks, excessive wear or other damage.
•
Never
light the gas grill with the lid closed or before
checking to insure the burner tubes are fully seated over
the gas valve orifices.
•
Never
allow children to operate the grill. Do not allow
children to play near the grill.
•
Never
obstruct the flow of combustion and ventilation
air to the grill.
WARNING
WARNING
Fire Risk
Explosion Risk
A strong gas smell, or the hissing sound of gas indi
-
cates a serious problem with the gas grill or the LPG
cylinder.
• Get away from the LPG cylinder.
• Do not try to fix the problem yourself.
• Call the fire department. (Do not call near the LPG cyl
-
inder because the telephone is an electrical device.)
Failure to immediately follow the steps listed above
could result in a fire or explosion which could cause
property damage, serious bodily injury or death.
CAUTION:
Spiders and small insects occasionally spin
webs or make nests in the grill burner tubes during tran
-
sit and warehousing. These webs can lead to a gas
flow obstruction which could result in a fire in and
around the burner tubes. This type of fire is known as
a “FLASH-BACK” and can cause serious damage to
the grill and create an unsafe operating condition for the
user.
Although an obstructed burner tube is not the only cause of
“FLASH-BACK”, it is the most common cause.
To reduce the chance of “FLASH-BACK”, clean the
burner tubes before assembling the grill, and at least
once a month in late summer or early fall when spi
-
ders are most active. Also perform this burner tube
cleaning procedure if the grill has not been used for an
extended period of time.
Natural Gas Safety
(Conversion Kit available through Fire Stone)
This converted natural gas grill is designed to operate on
natural gas ONLY, at a pressure of 7” water column (W.C.)
(1/4 psig or 1.75 kPa), regulated at the residential meter.
Check with the gas utility for local gas pressure and with
the local municipality for building code requirements. If the
residential gas utility line pressure has not been regulated
to 7” W.C., contact the local gas utility or gas grill dealer for
professional assistance.
Check with the gas utility or with local building codes for
instructions to install gas supply line, or call a licensed and
knowledgeable installer. The grill must be chained to stay
in one location so that it cannot roll.
It is recommended that an “ON-OFF” shut-off valve be in
-
stalled at the gas supply source:
• outdoors after gas line piping exits outside wall and before
quick-disconnect, or before gas line piping enters ground.
• indoors in the branch fuel line in an accessible location
near the supply line.
Converting to Natural Gas
Fire Risk
Explosion Risk
Only factory authorized dealers may convert the grill
from LP to NG.
• Any attempt to do otherwise voids the product war
-
ranty and releases Fire Stone from all liabilities due
to unauthorized conversion.
• Failure to comply with these instructions could re
-
sult in fire or explosion which could cause property
damage, serious bodily injury, or death.
Pipe sealing compound or pipe thread tape of the type re
-
sistant to the action of natural gas must be used on all male
pipe threads when making the connection.
Disconnect the gas grill from fuel source when the gas sup
-
ply is being tested at high pressures. This appliance and its
individual shut-off valve must be disconnected from the gas
supply piping system during any pressure testing of that
system at test pressures in excess of 1/2 psi (3.5kPa).
Turn off the gas grill when the gas supply is being tested
at low pressures. This appliance must be isolated from the
gas supply piping system by closing its individual manual
shut-off valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than 1/2 psi
(3.5kPa).
