Contact us for assistance: (866) 985-7877 | www.wtliving.com
4
ASSEMBLY
1
2
PREPARATION
1
2
Top Bracket
Hardware Used:
D
Top Bracket
x
1
You will assemble the wind guard upside-down.
Loosen
the
set-screws in
one Top Bracket
D
, then
slide a
short and long
panel
of glass into
the bracket as shown
.
Align bracket with lower
edge
s
of
each
glass panel
.
Ensure
small silicone pad is in place
at
tip of
each
set
-
screw
-
do
NOT tighten metal screw directly to the glass. Over-
tightening may break glass!
Tighten set-screws until snug.
Repeat step 1 for remaining three corners.
Hardware Used:
D
Top Bracket
x
3
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If any parts are
missing, please contact Customer Service at (866)-985-7877, 9 a.m. -
9
p.m. EST or email at [email protected].
Carefully remove the wind guard from the packaging and inspect for any damage such as chips or cracks. Place glass panels
on a soft
,
flat surface to prevent any damage.
Before assembly, e
nsure that each bracket has 2 set screws
,
with
silicon inserts
attached
at the tip
.
Estimated Assembly Time: 30 Minutes | DO NOT over tighten hardware!
