12
OPERATION INSTRUCTIONS
DANGER
CARBON MONOXIDE HAZARD
For outdoor use only. Never use inside house, or other
unventilated or enclosed areas This fire pit consumes air
.
(
).
oxygen Do not use in unventilated or enclosed areas to
avoid endangering your life
.
Very hot while in a operation
!
Never lean over the fire pit while in use
.
Do not touch surfaces while the fire pit is in
operation wait until the fire pit has cooled down after use
,
.
Failure to comply with these instructions may result in
serious bodily injury
.
WARNING
Before Turning Gas Supply ON:
1 Your fire pit was designed and approved for outdoor use only Do NOT use it inside a building
.
.
,
garage or any other enclosed area
,
.
2 Make sure surrounding areas are free of combustible materials gasoline and other flammable
.
,
,
vapors or liquids
.
3 Ensure that there is no obstruction to air ventilation Be sure all gas connections are tight and
.
.
there are no leaks
.
4 Be sure the cylinder cover is clear of debris Be sure any component removed during assembly
.
.
or servicing is replaced and fastened prior to starting
.
Before Lighting:
1 Fire pit should be thoroughly inspected before each use and by a qualified service person at least
.
,
annually If relighting a hot fire pit always wait at least 5 minutes
.
,
.
2 Inspect the hose assembly for evidence of excessive abrasion cuts or wear Suspected areas
.
,
,
.
should be leak tested If the hose leaks it must be replaced prior to operation Only use the
.
,
.
replacement hose assembly specified by manufacturer The burner must be replaced prior to the
.
appliance being put into operations if it is evident that the burner is damaged The replacement burner
.
should be specified by manufacturer.
Lighting:
1 Turn the control knob to the “OFF”position Figure A
)
(
).
2 Fully open LP cylinder valve
)
.
Note For initial start or after any cylinder change hold Control Knob IN for
:
,
2 minutes to purge air from gas lines before proceeding
.
3 Push in gas control knob and turn counterclockwise to “IGNITE”
)
(
)
.
,
Figure B to light the fire pit If needed keep depressing and turning control knob
counterclockwise until the fire pit lights you should hear a clicking sound
(
).
4 After fire pit lights release control knob Push in and turn the control knob counterclockwise to
)
,
.
the “HIGH” Position then release control knob If you want a lower temperature push in the control
knob and turn counterclockwise to the “LOW” Figure C
(
).
Position
Note
:
If burner fails to remain lit, all valves should be closed and a waiting period of at least 5
minutes should pass before attempting to light
.
Caution
:
Do not attempt to operate until you have read and understand all General Safety Information
in this manual and all assembly is complete and leak checks have been performed
.
Figure A
OFF
Pu
sh
to
tu
H
r
G
n
I
H
LO
W
E
T
I
N
GI
Figure B
OFF
Pu
sh
to
tu
H
r
G
n
I
H
LO
W
E
T
I
N
GI
Figure C
OFF
Pu
sh
to
tu
H
r
G
n
I
H
LO
W
E
T
I
N
GI
Summary of Contents for 62195
Page 6: ......