P
AGE
4
OF
6
F
IRES
OF
T
RADITION
I
NSTALL
I
NSTRUCTIONS
FOR
O
CTAVIA
Use a black silicone to hold and insure
that the parts of the mantel do not shift
once they are in position. Run a bead of
the silicone along the bottom of the leg
where it comes in contact with the
hearth, and carefully lower it into posi-
tion. Install a side bracket onto the wall
using the appropriate wall plugs to se-
cure the leg into position. Secure the
other leg in the same fashion.
Make sure the firebox is centered on
the hearth!
Check their fit against the hearth. Care-
fully lower the beam into position be-
tween the two legs, to define the proper
distance between them. While carefully
holding these three piecs in place, posi-
tion the two leg brackets against the
granite lugs on the inside top of each leg,
and make a mark on the wall where the
hole in the bracket rests.
Remove beam and legs carefully, and
install the two wall plugs provided to se-
cure the leg brackets to the wall. You can
now install the firebox into its proper
position.
It is best to do a dry fit of the legs and
beams in order to locate the mounting
brackets. Carefully place the legs into
position on the hearth, making sure that
they are the correct end up.
Note; when placing any of the granite
parts take special care to not chip any
edges. This can easily occur when a part
isn’t placed properly and falls into place
when it is released.
Take care not to stand on the hearth as
this may cause it to lose level!!
Step #5
Step #4
Step #6
