FPX 32 DVS Artisan Face
Charcoal 98500507 Antique Copper 98500508 Antique Nickel 98500509
Page 4 of 4
17601079 - 5/10/10
© Travis Industries, Inc.
Opening the Control Door
Warning:
The face becomes very hot during operation. Use the included handle open the control and
take care to not touch any of the hot surfaces.
Use the pull tool
on either side to
disengage the
hinges.
Note how the hooks on the tool insert
into the triangle-shaped holes.
Control Door
When removing the
pull tool, make sure
it does not damage
the hearth.
Pull Tool
(included
with face)
Adjusting the Control Door
The control is adjsuted at the factory. See the directions below if further adjustment is necessary.
Back of Face (with face removed)
Bullet Catch
This bullet-shaped device holds the control door
upright. To tighten or loosen the catch, simple
rotate it (it is threaded inside the assembly).
Adjust this nut to tighten
or loosen the friction of
the hinge.
Back of Bullet
Catch
These two nuts hold the
bullet catch assembly.
If the top of the control
door is not aligned,
these nuts can be
loosened to re-align the
bullet catch assembly.
Access
Panel
