Discard JST Plug
Cut 2-1/2” Long
Retain for
later step
Locate the VTX power wire with
the JST plug installed. This wire
will need to be modified for two
applications in the following steps.
Cut the JST plug off close to the
connector. Discard the plut. From
the remaining wire, cut a section
of wire 2-1/2” long. You will use
this wire to power the flight con
-
troller from the PDB later in the
manual.
The remaining wire with the white
plug attached will power the VTX
and camera simultaneously.
Solder the VTX power leads to the
ground and 12V tabs on the PDB
as shown in photo to left.
Locate the 4” piece of 16 AWG
wire and cut in half. Solder one
end of each with to the PDB.
Leave the other end of the wires
unattached. These will be soldered
to the HCT plug after the wires are
fed through the frame.
NOTE:
Maintain proper polarity.
7
