REV. A Page 3
ESTOP-RM-KIT
Step 5
: Install the (4) 10-24 x 1.25” Phillips screws through
the mounting brackets, into the wall board holes and secure
with a washer and nut (on back side) for each hole.
PUSH TO STOP
TURN TO START
OFF
TURN
PAST
Fig. 4
Shows ESTOP mounted into wall.
PUSH TO STOP
TURN TO START
OFF
TURN
PAST
Cover Plate
Step 6
: Install the cover plate overtop of the ESTOP gas
timer. Align the holes in the cover plate with the holes in
the ESTOP gas timer (top and bottom) and install the two
(2) mounting screws (#10-24x6.25 SS Phillips screws) to
secure the cover plate as shown in Figs.5 and 6.
Wall Board
Cover Plate
Mounting
Screw
Mounting
Screw
Fig. 5
Installing cover plate.
Fig. 6
Side view of ESTOP mounted into wall.
Step 7:
When cover plate is installed over the ESTOP gas
timer it will protrude
⅞
”. See Fig. 7 for outside dimensions.
PUSH TO STOP
TURN TO START
OFF
TURN
PAST
5¾”
6¾”
Fig.7
Cover plate outer dimensions.
Step 8:
After the ESTOP-RM-KIT is installed then use gas
rated Teflon tape on the gas lines to connect gas supply.
Ensure you check for gas leaks before final operation.
