Kalea Bay See-Thru Conversion Kit
REV. 4-15-19 Page 3
Step 1: REMOVING BACK REAR PANEL
Look at the back side of the fireplace. Around the outer perimeter area of the back wall are several 1/4” hex head screws
that must be removed (See the shaded area in Fig. 2). Only remove the top and bottom screws on the rear panel. The
nailing flange will remain in place. The back wall panel will remain in one piece.
CAUTION:
Watch for sharp edges.
Note:
The numbers of screws to remove will vary with each fireplace model. The back panel will not be used again.
Discard back panel and replace the screws previously removed.
Fig. 2
Removing back wall to convert to see-through model.
BACK VIEW REAR PANEL INSTALLED
Side View Detail for Removal Rear Panel Screws
Nailing Flange
Bottom Fin
Valve
Box
Back
Wall
Nailing Flange
Na
il
i
n
g
fl
a
ng
e
d
e
t
a
il
