Contact us for assistance: (866) 985-7877 | www.wtliving.com
11
OPERATING INSTRUCTIONS
CAUTION
Do not attempt to operate until you
have read and understand all General
Safety Information in this manual and
all assembly is complete and leak
test has been performed.
B
EFORE TURNING GAS SUPP
LY
ON:
1. Your fire pit was designed and approved
for outdoor use only. Do NOT use it
inside a building, garage, or any other
enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and
other flammable vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections
are tight and there are no leaks.
4. Be sure the cylinder is clear of debris. Be sure any component removed during
assembly or servicing is replaced and fastened prior to starting.
IGHTING
BEFORE L
1. Fire pit should be thoroughly inspected before each use, and by a qualified service
person at least annually. If relighting a hot fire pit, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear.
Suspected areas should be leak tested. If the hose leaks, it must be replaced
prior to operation. Only use the replacement hose assembly specified by
manufacturer.
WARNING
Very hot while in operation!
Never lean over the fire pit while in use.
Do not touch Table Top or burner
Assembly while the fire pit is in operation.
Wait until the fire pit has cooled down
after use before placing lid on Table Top
or touching any surfaces. Failure to
comply with these instructions may result
in serious bodily injury.
DANGER!
FOR OUTDOOR USE
ONLY
CARBON MONOXIDE HAZARD
Never use this inside a house, or other
unventilated or enclosed areas. This fire pit
consumes air (oxygen). Do not use in
unventilated or enclosed areas to avoid
endangering your life.
WHEN FIRE PIT IS ON:
Burner will display tongues of blue
and yellow flame. These flames
should not produce thick black
smoke, indicating an obstruction of
airflow through the burners. If
excessive flame is detected, turn off
fire pit and consult the
“Troubleshooting” section of this
manual.
L
IGHTING:
1. Turn the control knob to “OFF” position (Fig. A).
2. Fully open LP cylinder valve.
Note: For initial start or after any cylinder change, hold Control Knob IN for 2 minutes to purge
air from gas lines before proceeding.
3. Push in and turn the control knob counter clockwise to HIGH (Fig. B).
4. While holding control knob in, push the RED igniter button to ignite the main burner. Press repeatedly if necessary until the
burner lights.
5. After fire pit lights, release control knob. To decrease the flame, turn the control knob counter clockwise to LOW (Fig. C).
6. To increase the flame, turn the control knob clockwise to HIGH (Fig. B).
NOTE: If burner fails to remain lit, close all valves and wait at least 5 minutes before attempting to light.
Figure A
Figure B
Figure C
Igniter
LOW
HIGH
