ASSEMBLY
PREPARATION
Top Bracket
1
2
4
Hardware Used:
¿¿
C
Top
³>Ug¿
x1
Continue to join
Glass Panels
A
/
B
one at a time by the same
procedure as in S
YJU
until all four panels are in place to form a
rectangle.
Once all four
Glass Panels
and
Top Brackets
C
are in place, check
the security of all eight set screws.
Hardware Used:
¿¿
C
Top B
³>Ug¿
x3
You will assemble the wind guard upside-down.
Loosen the set-screws in one
Top Bracket
C
, then slide a
Short
Glass Panel
A
and a
Long Glass Panel
B
into the bracket as
shown.
Align the
Bracket
with the lower (top) edges of each
Glass Panel
.
Verify that a small silicone pad is in place
at
the tip of each
bracket set-screw.
Do NOT tighten the screw directly to the glass
if the pad is missing. Check the product packaging or contact
Customer Service.
Carefully tighten set-screws until snug.
WARNING: over-
tightening set-screws can break glass!
Contact us for assistance: (866) 985-7877 | www.balkenehome.com
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If any parts
are missing, please contact Customer Service at (866) 985-7877, 9 a.m. - 9 p.m., EST., or email
.
Carefully remove the glass panels from the packaging and inspect for any damage such as chips or cracks.
Place
glass panels on a soft, flat surface to prevent any damage. Before assembly, ensure that each bracket has 2 set-
screws, with silicone pads attached at the tip.
Estimated Assembly Time: 30 minutes | Do NOT over-tighten hardware!
