9
5.
Carefully route the Gas Hose (C) that comes attached to
Head and Upper Post Assembly (B) completely through the
Lower Post/Post Support Plate Assembly (E/F).
(Hint: Control knob on Head Assembly should be located over the Tank
Housing Door.)
6.
Attach Head Assembly and Upper Post Assembly (B) to the
Lower Post (E) by aligning the 4 small holes located on
the Upper Post with the 4 small holes located on the
Lower Post (E). Insert 4 M6x12 (EE) bolts through
4 M6 lock washers and into holes and tighten with a wrench.
Hardware Used
: 4 x EE, Bolt M6x12 and Lock Washer M6
7.
Assemble Reflector Panels and Center Cap (A). Reflector
Panels and Center Cap (A) come packaged in two brown boxes with
two panels in each box. Hardware for assembly is already affixed to
each panel. Place two panels side by side and remove the two cap
nuts and washers that are affixed to one panel. Insert the affixed
bolts into the open holes on the adjacent panel. Place the washer
over the bolt and screw on cap nut. Repeat these steps until all four
panels are assembled. Then locate the Center Cap. You will need to
remove the cap nuts and washers located at the top of each Reflector
Panel to allow assembly of the Center Cap on each panel. Align the
holes in the Center Cap with the bolts on each panel and affix washer
and cap nut to complete assembly. (
Note
: It is easiest to assemble
reflector panels if you turn panels upside down. Once 4 panels are
assembled, turn reflector right side up and then attach the cap.
)
ASSEMBLY
7
5
6
Summary of Contents for 60950
Page 3: ...3 SAFETY INFORMATION...
Page 4: ...4 SAFETY INFORMATION...
