background image

A 15 Amp, 110 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this
appliance. The fireplace must be on a dedicated circuit as other appliances on the same
circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in opera-
tion. The unit comes standard with a 6.5 ft long 3 wire cord, exiting out the back of the
fireplace. Plan the installation to avoid the use of an extension cord. If an extension cord
must be used, it must be a minimum 14 gauge, 3 wire with grounding type plug and
connector and rated not less than 2025 watts. The extension cord shall not be more than
20 ft in length.

ELECTRICAL CONNECTION

SPECIFICATIONS

Dimensions LxWxH

Net Weight

Voltage

Frequency

Watts

Heater Rating

15.56"x23.09"x28.37"

54.5 lbs

110-120V

60 Hz

1350 W

4600 BTU

WARNING:

Electrical outlet wiring must comply with local building codes and other

applicable regulations to reduce the risk of fire, electrical shock and injury to persons.

WARNING:

Do not use this firepla

c

e if any part of it has become wet. Immediately call a 

qualified service technician to inspect the fireplace and replace any part of the electrical
system which has been wet.

17.

18.

Use this appliance only as described in this manual. Any other use not recommended 
by the manufacturer may cause fire, electric shock or injury to persons.
Avoid the use of an extension cord because the extension cord may overheat and 
cause a risk of fire. However, if you have to use an extension cord, the cord shall be 
14 gauge minimum size and rated not less that 2025 watts. The extension cord must
be a three wire cord with grounding type plug and cord connector. The extension 
cord shall not be more than 20 feet in length.

Summary of Contents for 60353







Reviews: