Á>UÁ¿É¸¿tµ¿>¸¸¸Á>Ug[¿¿£l½½¤¿lu¼l¼¼¿¿N¿¿ÑÑѦ
balkenehome
¦U¿
¿¿¿¿
2
"*,/ ½ -/,1/" -
1.
Smell all around the unit area for gas. Be sure to smell near the floor,
because gas
is heavier than air and will settle to the lowest point. If you
smell gas, shut off the
gas to the appliance, extinguish any open flame,
and if odor persists, call your gas
supplier or the fire department.
2.
Fire pit should be thoroughly inspected before each use, and by a
qualified
service person at least annually. If relighting a hot fire pit,
always wait at least 5
minutes.
3.
Inspect hose assembly for evidence of excessive abrasion, cuts, or
wear.
Suspect areas should be leak tested. If the hose leaks, it must
be replaced prior
to operation. Only use the replacement hose
assembly specified by
manufacturer.
DANGER!
FOR OUTDOOR USE
ONLY
CARBON MONOXIDE HAZARD
Never use this
fire pit
inside a house or
other unventilated or enclosed areas.
This fire pit consumes air (oxygen). Do
not use in unventilated or enclosed
areas to avoid endangering your life.
WHEN FIRE PIT IS ON:
Burner will display tongues of blue and yellow
flame. These flames should not produce thick
black smoke, indicating an obstruction of
airflow through the burners. If excessive flame
is detected, turn off fire pit and consult the
Troubleshooting
section of this manual.
L
IGHTING:
NOTE:
Use only your hand to depress or turn the gas control knob. Never use tools. If the knob will not depress or turn
by hand, DO NOT try to repair it. Call a qualified professional service technician. Force or attempted repair may
result in fire or explosion and will void the warranty.
1.
Turn the control knob to “OFF” position (Fig. A).
2.
Fully open LP cylinder valve.
Note: For initial start or after any cylinder change, hold Control Knob IN for 2 minutes to
purge
air from gas lines before proceeding.
3.
Push in and turn the control knob counterclockwise to HIGH (Fig. B).
4.
While holding control knob in, push the Electronic Ignition button to ignite the main burner. (The ignition will produce
a soft snapping/crackling sound. If the fire pit does not light and there is no snapping sound, replace the battery.)
5.
After fire pit lights, wait 45 seconds, then release control knob.
6.
Observe the flame height when lit. Flame should reach between 3 and 13 inches in height. Overly short or tall flame
can indicate a problem.
7.
To decrease the flame, turn the control knob clockwise to LOW (Fig. C). To increase the flame, turn the
control knob
counter
clockwise to HIGH (Fig. B).
NOTE: If burner fails to remain lit, close all valves and wait at least 5 minutes before attempting to light.
LOW
HIGH
Figure B
Figure A
NOTE:
This model has an Electronic Igniter and
requires one AAA battery. Unscrew IGNITER
BUTTON to install.
Electronic igniter
requires
AAA battery
BEFORE
L
IGHTING:
SHUT DOWN:
1.
To extinguish burner
depress control knob and
turn it
clockwise to OFF.
2.
Turn cylinder valve
clockwise to OFF and
disconnect
regulator when
fire pit is not in use.
AFTER
-
OPERAT
I
ON
CHECKLIST
:
1. G
as control knob is in
OFF
position.
2.
Gas tank valve is OFF.
3. G
as line
is disconnected
.
Figure
C
