11
Step
20
Using 2 x 16mm spanners to
adjust the position of platen
backrest to your personal
preference.
Note: You can adjust the
position of the backrest
forward, back, left and right
to your desired position.
Step
21
Install tool rest (if supplied)
to the lower tool arm receiver,
secure using supplied locking
handles.
Step
22
Double check all bolts,
attachments and levers are
firmly secure.
Step
23
Slowly rotate the belt towards
you by hand, to check the
tracking wheel alignment.
The tracking is adjusted by
rotating the hand screw on the
left side of the grinder. This
changes the angle of the
tracking wheel and thus the
position of the belt on the
platen.
*On first use the hand screw
may be very tight. This should
loosen substantially after the
first ¼ turn. A small drop of
Loctite has been used to
prevent vibrations affecting the
tracking.
Step
24
Securely mount your Variable
Speed Drive (VSD) according to
mounting instructions included.
The supplied drives are IP66
rated and are completely dust
proof, and can take high
pressure water spray. They
should not be permanently
mounted in direct sunlight.
Step
25
Securely mount your Fire Ant
Grinder to your bench or post
using the mounting holes in the
base of the frame, and the
motor mount holes where
nessasary.
