17
4.
Push down A control knob and turn it anti-clockwise to the big
“ ”
position, a click will be heard, this will light the burner. If not repeat this
process 3 or 4 times.
5.
If the burner has not lit, wait 5 minutes and repeat step 4.
6.
When the burner is alight, repeat step 4 and 5 to light other burners.
7.
Adjust the heat by turning the knob to the High/Low position.
8.
To turn the barbecue off: turn the cylinder valve or regulator switch to
the ‘OFF’ position and then turn all control knobs on the appliance
clockwise to the ‘●’ position.
IGNITION
: Plug type gas valve with integrated piezo ignition.
WARNING:
If the burner fails to ignite, turn all control knobs off (clockwise)
and also turn the cylinder valve off. Wait five minutes before attempting to
relight the burners.
Before cooking for the first time, operate the barbecue for about 15 minutes
with the l
id closed and the gas turned on HIGH. This will “heat clean” the
internal parts and dissipate odour from the painted finish.
Clean your barbecue after each USE. DO NOT use abrasive or flammable
cleaners, as it will damage the parts of the product and may start a fire. Clean
in warm soapy water.
WARNING: Accessible parts may be very hot. Keep young children away
from the hot appliance at all times (even while cooling down!). It is
recommended that protective gloves (eg oven gloves) be used when handling
particularly hot parts.
CLEANING AND CARE
CAUTION:
All cleaning and maintenance should be carried out when the
barbecue is cool and with the fuel supply turned OFF at the gas
cylinder.
OUTSIDE SURFACE
Use mild detergent or baking soda and hot water solution. Non-abrasive
scouring powder can be used on stubborn stains, then rinse with water.
If the inside surface of the barbecue lid has the appearance of peeling paint,
baked on grease build-up has turned to carbon and is flaking off. Clean
thoroughly with strong hot soapy water solution. Rinse with water and allow
to completely dry.
NEVER USE OVEN CLEANER.
INTERIOR OF BARBECUE BOTTOM
Remove residue using brush, scraper and/or cleaning pad then wash with a
soapy water solution. Rinse with water and allow to dry.
