Fire-Lite LDM-32F, Instruction Manual

Page: 36 / 64

Appendix A: Sensiscan 2000 Lamp/LED Driver Operation
36
LDM-32F PN 50055:C 03/20/01
The following table defines the point assignments if incorporating the optional
modules available on the Sensiscan 2000.
Table 5 Optional Modules Annunciator Point Assignment to LDMs
Optional
Modules
Alarm
(Red LED)
Trouble/Supv
(Yellow LED)
Control Switches
1
1. Optional control switches are active only if all of these conditions are met:
a) '8-Point Shift' (DIP switch #4) is set to OFF.
b) Receive Only (DIP Switch #5) is set to OFF.
c) Switch Inhibit (DIP Switch #7) is set to OFF.
IZ-8F Alarm Status per
Circuit Trouble Status per
Circuit
Not Used
IZ-4F/IZE-4F Alarm Status per
Circuit Trouble Status per
Circuit
Not Used
IC-4F/IC-4CCF
Indicates
Activation
2
2. These Status LEDs are active only when the Sensiscan 2000 is programmed for Output
Status. Use green LEDs to indicate activation on controlled output circuits.
Indicates Trouble
per Circuit
Momentarily Turns
On NAC Output
When Pressed
3
3. These control switches require that the Sensiscan 2000 be programmed for Output Control.
ICE-4F
Indicates
Activation
2
Indicates Trouble
per Circuit
Momentarily Turns
On NAC Output
When Pressed
3
CR-4F/CE-4F Indicates
Activation
2
Indicates Trouble
per Circuit
Relays
3
TC-2F/TC-4F Indicates
Activation
2
Indicates Trouble
per Circuit
Remote Switch
Functions
3