Fire-Lite Alarms I300-6 Installation And Maintenance Instructions Download Page 4

 

4 I56-4097-000 

 

 

©2014 Fire•Lite Alarms, Inc.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must 
accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 
reasonable  protection against harmful interference in a residential installation. This equipment generates,  uses and can radiate radio frequency energy and, if not installed and used 
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular instal-
lation.  If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to 
try to correct the interference by one or more of the following measures:
 

 

– Reorient or relocate the receiving antenna.

 

 

– Increase the separation between the equipment and receiver.

 

 

– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

 

 

– Consult the dealer or an experienced radio/TV technician for help.

Summary of Contents for I300-6

Page 1: ...ptions for I300 6 modules Up to six I300 6 modules can be installed on a CHS 6 in a CAB 3 CAB 4 or BB 25 cabinet One or two I300 6 modules can be installed in a BB XP cabinet Chassis The CHS 6 chassis is used to mount I300 6 modules in a BB 25 CAB 3 or CAB 4 Series cabinet It accommodates up to six I300 6 modules in a single cabinet row three modules wide and two modules deep I300 6 Six Fault Isol...

Page 2: ...ng to the instructions in this manual FIGURE 6C INSTALLATION OF I300 6 MODULE IN FRONT CHASSIS INSTALLATION STEPS 1 Cabinet Mounting In a clean dry area mount the backbox using the four holes provided in the back surface of the cabinet FIGURE 3 TYPICAL MOUNTING HOLE LOCATIONS BACKBOX MOUNTING HOLES 2 Chassis Installation The CHS 6 chassis is mounted in the BB 25 CAB 3 or CAB 4 Series cabinets It i...

Page 3: ...MING The I300 6 module operates with the following Fire Alarm Control Panels MS 9050UD MS 9200UDLS MS 9600LS MS 9600UDLS 6 8 5 8 FROM PANEL OR PREVIOUS DEVICE SIGNAL LINE CIRCUIT 32 VDC MAX TWISTED PAIR IS RECOMMENDED TO NEXT DEVICE STATUS INDICATORS FIGURE 7 WIRING AND PROGRAMMING THE I300 6 MODULE C0205 05 WIRING 1 Install module wiring in accordance with the job drawings and appro priate wiring...

Page 4: ...pment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular instal lation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equi...

Reviews: