10
Note:
Visually check the burner flame against the illustrations:
Flame should be blue with slight yellow tips.
You should see a smaller flame in LOW position than seen
on HIGH. Perform flame check prior to each use. If only low
flame is seen, refer to “Burner flame is low” in the
“TROUBLESHOOTING” on page 13.
Using a long match/lighter to light
1.
Check the control knob is in the OFF.
2.
Position a long lit match or lighter close to the
Pilot box.
3.
Push control knob in and rotate to
PUSH.
The burner should lit within 5 seconds
4.
If the burner fails to stay lit or becomes
extinguished,
turn the burner control knob to
OFF
, wait 5 minutes for gas to clear and then
repeat step 3.
NOTE:
If the burner does not ignite within the first few attempts of match/Lighter lighting, there is a
problem with the gas supply. Turn off the gas at the burner and tank. DO NOT attempt to operate the
unit until the problem is found and corrected. Please call the customer service department at
1-855-CHANT-US (1-855-242-6887) from 8:00am to 5:00pm Eastern time, Monday through Friday for
assistance.
1. Check the control knob is in the OFF position.
2. Turn on the LP tank valve slowly.
3. Push the knob in and turn slowly to produce a
spark.Once burner is lit, continue to hold the
control knob for 30 seconds. Then the burner
should stay lit.
4. If the burner fails to stay lit or becomes
extinguished in 30 seconds, turn the control knob
to OFF, wait 5 minutes for gas to clear and then
repeat step 3.
5. To desired heating level rotate knob from
HIGH
to
LOW
.
6. To turn off, turn the knob to
PUSH
first, then push
in and turn to OFF. Turn off the gas tank valve
before disconnecting the LP gas tank.
HIGH
LOW
OFF