The Tool/Axe Loop can be installed on any available Gear Loop, although the
recommended installation is on the second Gear Loop from the fixed Attachment
Point (D-Ring). REQUIRED TOOLS: None
AXE - TOOL HOLDER
Start by opening the unit and then slip the Plastic
Separator from the BOTTOM of the belt, and
between the belt and the second gear loop.
Fold the Reinforcement Flap over the belt and
gear loop.
Proceed by turning over the belt and, align and
fasten the Velcro Flap. The Axe/Tool Holder is now
installed.
back of belt view
front of belt view
front of belt view
Separator
Reinforcement Flap
Velcro Flap
Gear Loop
Start by setting the Top Adjusting Buckle to the
outside edge of the tool. Then singe the Main
Buckle down to secure the tool.
Top Adjusting Buckle
Use caution when donning/doffing your
belt with a tool in the Axe/Tool Holder.
Tool may fall and cause serious injury.
Main Buckle
