Accessory pouches allow stowage of the Multi-Use Strap as well as a multitude of firefighter
accessories such as tethers, gloves, etc.
The installation procedures shown below apply to all accessory pouches. These pouches are
recommended to be installed on the closest gear loops to the fixed Attachment Point (D-Ring). On
the Low Profile Pouch an additional step is required. Please note that at the end of installation, the
pouches will open upwards.
Open the Velcro flaps of the Belt Holder. The
separator should have the open side down.
Slip the separator from the TOP of the belt, and
between the belt and the gear loop.
Flip the bottom flap of the Belt Holder up.
Finally, turn down the top flap of the Belt
Holder and fasten the Velcro flaps securely.
LOW PROFILE ACCESSORY POUCH
This pouch has two Belt Holders to allow secured installation on either side of the belt. Follow the
procedures above for the front Belt Holder installation. Please note that it is NOT necessary to slip
the plastic flap through the gear loop of the rearward Belt Holder.
After securing the first
Belt Holder
, open
the rearward
Belt Holder
flaps and lay belt
directly on top of the plastic separator.
Close the flaps to fasten Velcro flaps.
Gear Loop
Separator
front view
back view
back view
Rearward
belt holder
ACCESSORY OR BAILOUT POUCH
front view